The goal is to keep rinsing until the water runs clear.
If there’s any loose dirt, this is a good time to tip it into a bin..Step 3: Rinse The Filter With Cold Water.
Hold the filter and tap off loose dirt into a bin.You don’t need to whack the filter – a gentle tap is enough!.If there is still visible dirt on the filter after tapping it off, you’ll need to clean it:.
Rinse the filter under a. cold tap.until the water runs clear.
Do not use hot water or any detergent.. Gently squeeze out excess water (not too hard though!).
Allow the filter time to.These instructions are specifically for the.
Dyson Cyclone V10., but they also apply to the V11 (which has a similar design).
If you have a Dyson V8, make sure you follow our separate guide to.replacing a V8 battery.