If you don’t fancy the drive to us, we also offer an easy service where you can.
One common mistake is assuming the foam seal replaces the visible rubber O-ring near the hose inlet assembly’s connection to the bag.This foam seal fits deeper inside the housing, in a location that is not immediately obvious..
The number of screws you need to remove will depend on your model:.On later X4 and X7 models, you will usually need to remove two screws.On earlier models like the X1, and early X1.1 and X4, there is typically only one screw at the top.
Once opened, you will often find the old seal has disintegrated.The new foam seal sits neatly around the circular opening inside, and is held in place once the internal section is twisted back into position.. Not Sure Which Seal You Need?.
If you are unsure whether it is the.
foam inlet seal.As Sebo parts specialists, our parts prices are always competitive.
We supply the trade with spare parts too.. Another Good Reason To Repair an Older Sebo Vacuum.In 2017 the EU imposed upon us a maximum wattage limit of 900w for all vacuum cleaners.
Despite the UK leaving the EU, the government shows no sign of rescinding that rule.BBC Breakfast did a feature on those rules in our shop with our Sebos which you can watch here..